Steps to follow
Step 1: Remove the Back Plate
- Remove all screws around the back plate (10 total).
- Set the back plate aside.
Step 2: Insert the iPad
- Place the iPad onto the faceplate.
- Ensure the charging port aligns with the cutout.
- Press down firmly on all four sides to secure it.
Step 3: Connect the USB Hub
- Flip the faceplate to the side to avoid damage.
- Plug the USB-C cable into the iPad.
Step 4: Reattach the Back Plate
- Align the screw holes with the standoffs.
- Reinstall all screws to secure the back plate.
Step 5: Install the Camera
- Ensure the camera is in manual mode.
- Extend the lens into the shooting position.
- Insert the camera into the bracket.
- Route cables through designated areas.
Step 6: Connect Camera Cables
- Insert the dummy battery and connect the power cable.
- Plug in the micro USB (or USB-C for R100).
- Slide in the hot shoe flash trigger.
Step 7: Power the Booth
- Use either a 12V battery pack or power supply.
- Ensure the battery is fully charged and turned on.
Step 8: Configure Camera Settings
- Disable auto power-off.
- Disable Wi-Fi to prevent connection issues.
Step 9: Set Up Photo Booth Software
- Download and install the software (PhotoFlix/Booth.Events).
- Ensure the camera is detected in the app.
- Adjust ISO, shutter speed, and aperture for optimal lighting.
Final Checks
Once all steps are complete, take a few test shots to verify everything is working correctly. If you run into issues, refer to our Knowledge Base for troubleshooting guides. Happy Boothing!
